Water Softener Valve Position

These are the inlet and outlet hoses for water moving through the softener.

Water softener valve position.

The bypass valves are located where the water softener connects to the water pipes. The rotor position switch tells the timer what position the rotor is in so the timer knows when to start the motor that turns the valve rotor through cycles. Normally the valves are in a horizontal position when the. This diy repair guide explains how to replace the rotor position switch in a water softener.

This article explains how to use repair the water softener or water conditioner system bypass valve. Check the valves positions. Locate the water softener then look for 2 large hoses running out of it normally either out of the side or the back. One on the inlet one on the outlet and one on the main line.

Also open the valves to the water heater and restore its power and or turn the gas valve back on and relight the pilot if necessary see how to relight a gas water heater. Water softener bypass valve operation repair guide. This is usually behind the water softener s control box. Follow them to lead you to the bypass valve.

There are usually three valves. Turn the water supply valve completely on when a steady stream of water appears at the drain. Find the valves by following the 2 large hoses running out of the water softener. We explain what is the bypass valve on a water softener where to find it and we describe when how to position the valve to take the water softener conditioner in or out of service.

7 set the bypass valve to the bypass position and turn on the water to run through the softener for a few minutes to flush out sediment and expel air in the pipes.