Water Softener Regeneration Process

Water softener regeneration process.

Water softener regeneration process.

During regeneration salty water from the brine tank flows up the fill tube and into the softener tank. It is not recommended to use water during a water softener regeneration as hard water will fill the water heater which could lead to buildup in the equipment. How often a water softener will regenerate or recharge is controlled by the valve of a water softener system. This step takes about 10 minutes.

The regeneration process starts with a backwash during which the softener pumps water backward through the treatment medium to remove sediment. Other considerations depending on the size of your water softener a regeneration cycle typically takes about 30 to 60 minutes and uses anywhere from 40 to 60 gallons of water. But first let s discuss why regeneration occurs. A rinse cycle commences and the salty water washes the mineral deposits off the resin beads.

The valve or control valve is the brain of the softener unit since it gives the commands as to when the softener regeneration process will occur. To learn the exact process by which you can initiate a manual regeneration on your water softener consult your water softener s owner s manual. During the regeneration process the flow of water is extended to flow back through the softener through the use of a water loop. Water softener regeneration is the process which the softener system removes the existence of calcium and magnesium as well as other minerals and dirt from the water.