Here s how to test a suspected thermocouple in a gas operated water heater.
Water heater thermocouple tester.
How to test a thermocouple.
A faulty thermopile may be at fault.
Discretion should be used if the reading is between 21 and 25.
Once it is removed you will need a multimeter that needs to have the ability to read millivolts and a source of fire.
Thermocouple thermometer 50 300 degree industrial temperature meter j k t e n r s type thermocouple dual channel temperature meter tester lcd backlight 3 9 out of 5 stars 7 22 99 22.
If you can t light the pilot the problem most likely lies with the gas control valve or the gas flow itself not the thermocouple.
If the pilot light doesn t stay lit check the gas water heater thermocouple by keeping the pilot button depressed.
Light the pilot by pressing and holding the pilot light button on the gas control valve.
Thermocouples designed for residential gas appliances such as fireplaces water heaters and furnaces are made for 30 millivolts.
One probe of the meter should be connected to the copper sheath of the thermocouple and the other to the gas valve.
Originally it had a ratio of copper and nickel and was labeled a coppel copper nickel element.
It is comprised of two different types of metal which react differently to heat and expand at different rates signaling to the water heater when to turn on or off.
The water heater thermocouple is a device that monitors temperatures in the water heater to determine whether it needs to heat up or turn off the heat.
Thomas seeback discovered it in 1821.
The reading should be between 25 and 30.
If the thermocouple is working you should be able to measure 30 to 40 millivolts of voltage at the connection end of the tube when the pilot flame is on.
A gas water heater in boise baton rouge buffalo or boston uses a thermocouple that includes a probe attached to a copper tube that screws into a port on the gas valve.
Acceptable range for most water heat.
For testing a thermocouple you first have to remove it from the furnace water heater or gas appliance where it is installed.
Pilot light keeps going out.
To make certain the thermocouple is bad you have to test it.
How to test a thermopile s voltage using a multimeter.
In the early 1900s honeywell applied it to the safety gas valve.
Measure the current by using the multimeter device set on millivolts.
