Water Heater Rod Connection

Check that the water heater s power and water are turned off.

Water heater rod connection.

I poured 3 hydrogen peroxide in the water heater tank. Installed this new anode rod. Since most water heaters use a standard 3 4 npt connection you simply need to choose the type of installation you have. Your anode rod is a long skinny rod that sits inside the water heater and prevents your tank from corroding.

Per 10 gals of heater size 4. Water heater anodes and parts. Allow the water to cool then drain the tank to a level that is lower than the t p valve. Once the water within the tank is below the t p valve unscrew the valve using a pair of channel locks.

The water heater only requires 2 hot 120 volt wires to heat water and function. Open a nearby hot water tap to allow the air to flow into the tank. It was a horrible mess. If hidden an easy solution would be to remove the nipple on the hot water side with a pipe wrench and install a nipple outlet anode rod.

Most gas or electric water heaters require a standard rod length of 44. I believe the center wire on the 3 prong outlet is a neutral wire and i ve read that using neutral for chassis ground is never a good idea. You see over time corrosive agents in your home s water eat up the inside of the water heater. A few newer plastic lined tanks have no anode rods to replace before you get started close the shutoff valve turn on the hot water at a faucet to relieve pressure and turn off the electricity or gas to the heater.

I drained my water heater 2. Our products are designed with the recommended manufacturer s care and maintenance guidelines of residential and commercial grade hot water tanks because a water heater is a home or business s trusted investment and necessary component. Removed the old anode rod. Hot water faucet near the tank to remove air from tank while filling.

The water heater is only 5 months old. Metal electrical box on the wall or ceiling nearby run the old wires to the box and then run a new section of armored cable or electrical conduit to the water heater. The rod may be under the water heater s sheet metal top or connected to the hot water outlet nipple. If you have a separate inlet for the anode rod but can t get the old one out or the connections are too corroded to install the new one you can always install the new on the hot water outlet.

If the new water heater is shorter and the old wires won t reach surface mount a 4 in. But the anode rod is designed to attract all those corrosive agents and sacrifices itself so that your water heater tank doesn t corrode.